Show off your minifigures in style with this solid wood floating display shelf case.  Five different shelves embedded with 1x plates give you enough room to display 40-50 standard size minifigures.  Hanging the unit is easy using the two keyhole slots in the back that allow the shelf unit to sit flush against the wall.  
 
The shelves and frame are handcrafted from solid select pine and will be sanded smooth and finished with your choice of stain and clear coat on all exposed sides to enhance the beauty of the wood and make it smooth to the touch.  (*The back side facing the wall is not finished.)  
 
Stain choices are:
 
•        Clear
•        Golden Oak
•        Slate Gray
•        Dark Walnut
•        Red Mahogany
 
The display shelf shown in the pictures is stained in “Clear.”  See the last picture to see examples of all the different stain choices applied to pine.  See the second to last picture to see some different stain/plate color combinations.  The stain/plate color used in that picture are as follows, starting in the top left corner and going clockwise - dark walnut/white, golden oak/yellow, slate gray/red, golden oak/dark gray.
 
Shelf dimensions are as follows:
 
•        Total Height: approximately 15 ¾””
•        Total Width: approximately 11 9/16”
•        Total Depth: approximately 1 ½”
•        Shelf Dimensions: approximately 10 1/16” wide x 1 ½” deep with 1x plate set ¼” back from front edge, each shelf section is approximately 2 1/4” tall
•        Block Plates: 1x32 studs for each level – enough to fit 8 standard size minifigures on each level with two-stud spacing between each figure
 
Listing is for the shelf and includes the embedded plates – props and minifigures used in the listing pictures are not included.  I source my plates brand new or from sellers on Etsy or other collectors. Some of them have been slightly used, but I will not use any plates that are dirty or have obvious damage.  Some plates may have minor scratches or blemishes.  Plates are embedded into the shelf grooves using hot glue.  They can be pried out if necessary, but you should consider them permanent as they will be difficult to remove without damaging the shelves.
 
* Please note that all pictures are from a model shelf unit.  Each shelf is like a fingerprint – slightly different and unique due to variations in the grain, color, and patterns present in the wood used for that particular unit.  This adds to their beauty and makes them uniquely yours!
 
LEGO® is a trademark of the LEGO Group of Companies which does not sponsor, authorize, or endorse this product.